Posted 20 Mar 2015 (edited) I have 4 General Electric Multilin PQMII-T20-A power quality meters connected on a daisy chain RS485 2 wire half duplex network with baud of 19200. they are addressed as nodes 1,2,4 & 6. the RS485 network is connected to a Modbus Ethernet/RS485 convertor which i have setup with IP 10.15.35.126 for my network, the port used in the convertor documentation is port 502. i need some help to get Citect to pull a tag out of this network. my issue is the comms setup of citect. i have attached my screen shot of citect setup (Citect is V7.2). thanks in advance for any help on this issue. Edited 20 Mar 2015 by EICS Share this post Link to post Share on other sites
Posted 21 Mar 2015 all sorted with this issue now. found i had a setting incorrect in citect. Share this post Link to post Share on other sites