Sign in to follow this  
Followers 0
gleblanc

Modifying existing enclosure doors

3 posts in this topic

I've got a PLC cabinet with an existing HMI, plus 10 or so 30mm push buttons mounted below the HMI. I'm looking at replacing the HMI with a new larger model, and suspect that it would be easier to cut a new hole in the door than to replace the door (the door is approximately 6'x5'). I'm a little concerned about swarf from cutting the door winding up in the buttons somewhere. Turning power off to this isn't a problem, so I think it should be safe while performing the work, the only concern is shorting something out. What are the best tools to cut these doors with? Thanks.

Share this post


Link to post
Share on other sites
Depending on the size of the square.....mostly I would use a Jigsaw.

Share this post


Link to post
Share on other sites
...plus duct or masking tape and panters drop cloth to cover everything beneth and behind the cut. If possible support the door in the open position and cover the opening to keep chips out of the cabinet. Edited by RussB

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0