Sign in to follow this  
Followers 0
lostcontrol

CJ1-ETN21

5 posts in this topic

It would be really good if I could add a gateway to a customers ETN21 without having to stop the PLC, can this be done? I know there are restart bits that can be set independant of the CX-Programmer, but do they work? Or is the only way to set these parameters via the CX-Programmer configuration GUI's?

Share this post


Link to post
Share on other sites
Not sure, but you shoud try to access the ETN21 using internet explorer. As i remember, there you can set up almost every parameter as in cx-programmer, and then you should restart only ETN21 unit. check the manual for accessing the unit using IE (or any browser). regards

Share this post


Link to post
Share on other sites
here is the link: http://www.myomron.com/index.php?action=kb&article=1254 regards

Share this post


Link to post
Share on other sites
After setting the gateway, you can use the A501.xx CPU Bus Unit restart bit. xx = the Unit Number of the ETN21.

Share this post


Link to post
Share on other sites
Thanks guys, Hopefully I will get a chance to get back to site today to do this.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0