How to lock out numerical inputs GT Designer 3

[AO Engineer 0]

I am having problems with technicians adjusting set values on my equipment and it is greatly affecting quality. Is there a way for me to set a PIN number on numerical inputs? I need only a few people to be able to adjust these settings when operation calls for it. I wish simply explaining that changes have unseen effects would deter them from changeing inputs but that simply doesn't work. I need a way to make sure only tech supervisors can adjust them. Any ideas?

[Crossbow 277]

Enable project security and set password for level 1. Then set those objects you wish to lock to visible to level 0 but input level 1.

[AO Engineer 0]

Thank you! My issue now is that when I do this I can no longer input any value. How do you activate level 1? I set the PIN at the location shown in the pic I have attached. When I upload to the GOT and press the input value (D6060 D6062 D6064 D6066) on the screen it acts like I'm not pushing it at all. I was under the impression that when you press the value it should first prompt you for the pin then allow you to change the value. Any ideas? Thanks in advance.

[Crossbow 277]

No, you need to add a login button to the screen. That will ask for the password. Then you can add a logout button to set security level back to zero.

[pixieriver08 0]

On 3/7/2014 at 3:58 AM, Crossbow said:

No, you need to add a login button to the screen. That will ask for the password. Then you can add a logout button to set security level back to zero.

hello! i am trying this solution but i am stuck at adding the logout button. How exactly do i set this? I want the numeric input to ask for password every time the operator want to set it. Now the issue is that after I enter the password on the login button for the first time, the input is not protected by the security anymore unless i restart the plc and hmi

[MarkusR 0]

There are several of doing it,

If I understand you correctly you want to do following:

1. Log In

2. Enter the value

3. Lock out automatically.

Concentrating on this and assuming, we are only talking about couple of numerical inputs, you could do following:

Add a script to the numerical input, wich is activated after the new value is input. The script sets user level to 0.
This script you can add to your "Operation - Data Operation - Write"  (USER LEVEL * K0)
or you can use

"EXTENDED - Write Device" and trigger a script.

You are logged out.

 

Some other ways could be:

- Add a log out button, the button sets user level to 0

- Add a log out routine, 5 minutes after log in and no page movement has been recognized, set user level to 0.

 

I would show the current user level in the header of your screen when you have some real estate you have sacrifice.

[tiagru 2]

This is how I did password protection:

I have two different passwords for two levels of access; "Boom Selection" has one password and "Boom Parameters" has another. One password is stored in D80 and the other in D81. The password field is just a standard numerical entry object. I'm also bringing an "Incorrect Password" Dialog box.

 

Hope that helps.