Sign in to follow this  
Followers 0
Rohit

Autonics Stepper motor and drive

3 posts in this topic

I have a 2 phase stepper motor of autonics make ak2m243 and autonics drive md2u-id20, i want to rotate motor at a angle of 90 how can i do this there is no any information on its manual, Could any one help me for this thanx a lot.....

Share this post


Link to post
Share on other sites
I'm sure that the manual tell you how many pulses are in a complete revolution of 360 degrees. Tell the controller to move 1/4th of that.

Share this post


Link to post
Share on other sites
thanx for reply, but there is no such information i have attach the manual copy. there are two models in autonics Md2u series "md2u-md20" and "md2u-id20", In "md2u-md20" there are dip switches for resolution and angle but i have "md2u-id20" in which there dip switches only for rpm. MD2U.pdf

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0