Autonics Stepper motor and drive

[Rohit 0]

I have a 2 phase stepper motor of autonics make ak2m243 and autonics drive md2u-id20, i want to rotate motor at a angle of 90 how can i do this there is no any information on its manual, Could any one help me for this thanx a lot.....

[RussB 22]

I'm sure that the manual tell you how many pulses are in a complete revolution of 360 degrees. Tell the controller to move 1/4th of that.

[Rohit 0]

thanx for reply, but there is no such information i have attach the manual copy. there are two models in autonics Md2u series "md2u-md20" and "md2u-id20", In "md2u-md20" there are dip switches for resolution and angle but i have "md2u-id20" in which there dip switches only for rpm. MD2U.pdf