Sign in to follow this  
Followers 0
sttchui

Servo motor MR-H upgrade

2 posts in this topic

we have a project to convert Mitsubishi Servo Amp & Motor from MR-H upgrading but i very new to servo motor control i using TLAP (+10V Analog Torque Limit) & TLAN (-10V Analog Torque Limit) signal in CN1 of MR-H for Torque Control. can i use MR-J3 however, there is no TLAN signal for MR-J3. i noticed Thank you! Regards sttchui

Share this post


Link to post
Share on other sites
in that drive analog torque limits are set through TLA . fwd and rev limits are not controlled separately, this is a magnitude limit (absolute value). unless your application is sensitive and unbalanced (load on vertical axis) this should be no problem.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0