PanelView 1400e Upload fails

[Sector7 0]

I need to upload the program from a PanelView 1400e (2711E-T14C6X Series G, Rev D, FRN 5.16). I found software on ebay (PanelBuilder 1400e Config Software for Windows Cat No. 2711E-ND1, Series D, Release No 4.00.00). I am using a straight serial cable to connect the PC to the HMI. I have the HMI in Configure mode and the Transfer Software button. When I try to upload a program, I get an error (There is no current selected application on the panelview terminal for uploading). If I look at the HMI, it says I have an application selected. Could this be because of an old version of software and a newer HMI? Would it work if I transferred the application to a PCMCIA memory card, then use Panel Builder to read it? Thank you for any help.