upload omron program

[sulung 0]

Hi, i got a cj1m cpu11. i need to upload the program from plc. i use com 1 and connect to plc. i use auto connection. but could not connect. i got the plc progam from machine maker. but it was before commisioning. so i need the updated one. from the communication setting (program from machine maker) i see that the rs-232c port was set to custom mode rs-232c. i do not have the peripheral port cable.my question is what should i do to upload from plc?

[EasyButton 0]

Get the peripheral port cable. As far as I know there is no "manual" way to set the rs-232 port back to Hostlink.

[ECSI 17]

Turn on dip switch pin 5 on the front of the CPU. This will set the port to auto detect CX-Programmer settings.

[EasyButton 0]

Did not know that dip 5 would change custom rs232 to Hostlink. Seem to remember trying that. Huh! Thanks!

[sulung 0]

Thank you EasyButton, ECSI