Sign in to follow this  
Followers 0
klauricella

Mechatrolink with V1000 drive

5 posts in this topic

Has anyone tried to control a Yaskawa AC drive with Mechatrolink. I have a CP1H with a NCF71 controlling a couple servo would also like to control some V1000 drives just have not been able to find any info. Thanks Kevin

Share this post


Link to post
Share on other sites
I have used the W-series Omron servos on mechatrolink II, however CX Motion-NCF has the option to select an Unknown Drive within the NCF 71 config. Not to sure what data is required of the V1000 to import Have you checked out these manuals? http://www.yaskawa.com/site/dmdrive.nsf/(D...BPC73060049.pdf http://www.yaskawa.com/site/dmdrive.nsf/(D...EPC73060049.pdf Have you tried adding the drive to the Mechatrolink network? 1. Setting the unit number 2. Baud rate 3. Then go online to the NCF and upload from the card

Share this post


Link to post
Share on other sites
I tried all that and the servos connect with no problem. The NCF card does see them but shows a conflict. Any other ideas. I did hear from Yaskawa that this has been done before. Thanks Kevin

Share this post


Link to post
Share on other sites
What is the fault code displayed on the NCF card when this occurs? Any faults on the V1000's?

Share this post


Link to post
Share on other sites
Better late, than never. "SYSMAC CS/CJ Series Position Control Units CS1W-NC_71/CJ1W-NC_71 (Unit Version V2.0 or later). Inverter Operation Guide.": CS1W-NC_71/CJ1W-NC_71 Inverter Operation Guide

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0