Cable to program NV

[gagd03 0]

Hi, I bought a NV3W display to connect to my CP1L. I would like to know if someone have the programmation cable pinout? Cable between PC and NV... One end is DB9 (PC) and other end, is a miniDIN 5pin (MD-50 CUI inc.) The part number Omron is NV-TOL-3M. thanks, Gagd03

[NWSparky 0]

I just sold one to a customer and did not realize that it required the special cable for programming. So I was able to get the pinouts for both ends from help from tech support which took a bit. But if you want a cable made for you contact Bundles and More in Spokane WA and ask for the NV-TOL-3M-SPL and tell him what lengh you need, I had him make 2 each 6 inch long since they still require USB to RS232. www.bundles.com MB

[fercho 0]

I attach the pinout that I use.

[toy_bo 0]

On 2/1/2012 at 9:41 PM, fercho said:

I attach the pinout that I use.

Hi Sir,

May i have a copy also. Thanks

[polo 0]

On 9/13/2016 at 5:48 AM, toy_bo said:

hi i  am a new, i need a copy of    details pin out of  Cable between PC and NV3w , the cable  NV-TOL-3M thanks ...

 

On 9/13/2016 at 5:48 AM, toy_bo said:

 

 

[alfi_yasin 0]

On 01/02/2012 at 8:41 PM, fercho said:

I attach the pinout that I use.

Can i have it

[Michael Walsh 268]

@alfi_yasin @polo @toy_bo

I repaired the post above and re-attached the pinout that was originally there.

The site went through an upgrade a while back and some items were not connected to the forum post properly.