Sign in to follow this  
Followers 0
Donovanr

ABB ACS800 drives using positioning com to Contrologix via devicenet

1 post in this topic

Has anyone used ACS800 drives in positioning mode via encoder? Is the positioning loop done in the drive? ie send a command to the drive over devicenet and a start command, and the drive will carryout its command and respond its in position. I am keen to here from anyone else who has experienced these drives Edited by Donovanr

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0