Sign in to follow this  
Followers 0
OIDMBTRTECH

C200 CLK201

3 posts in this topic

Can this communications module be removed from the back plane hot? I have a customer with too many C200H's and 2 have the interface module. The PLC's we need to connect do not have one but do have 2 empty slots. The one's with the CLK201's run constantly and cannot be shut down easily. I have the correct CLK to PC cable.

Share this post


Link to post
Share on other sites
In short no with this, and most, PLCs. You will have to power down. Also, if there is an I/O table in the PLC this will have to re-created when the PLC is powered back up or the PLC will go into error because a card is missing. If there is no I/O table the PLC will power up normally into the run mode.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0