Search the Community

Showing results for tags 'transmitter'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 6 results

  1. FX3U Analog Programming

    Hi,  Anyone can help how to program a analog coming from a level transmitter? I have 8 analog inputs (2 unit of FX3U-4AD) to be read out into the plc program. how can this be possible. I'm new to mitsubishi analog. it is different from my experience(using siemens before).   Hope someone can help.   Thanks!!!   Marky
  2. Hello Friends; Good day. I am working in oil and gas industry. I search the net but cannot find the allowable pressure transmitter % span error. I can not find any API or IEEE document in which the industry standards  are mentioned regarding pressure transmitters upto 4000 PSIG and 1000 inches of water col.   Please share your experience.   Regards
  3. Hi, Recently, we replaced our old digital temperature transmitter with a Baumer Flextop 2201 digital temp transmitter. The application of the digital temp transmitter is for a hydraulic press and the output is fed to the Siemens S95-U plc. The Flextop was able to react properly promptly when there is increase in temperature but whenever there are sudden drops in temperature it is slow to react. The analog transmitter (dial) was already at 25 C when the hydraulic press was shut down while the Flextop was still at 35 C. We used a three wire configuration for this. Does this have to do with our wire configuration? I know there are 2 wire ,3 wire, and 4 wire configurations for 4-20 ma sensors but I'm not sure what are their differences among them. Please see attached configurations below.     Thanks,
  4. Version 1.0.0

    131 downloads

    Temperature measurement usind Arduino Nano, RTD PT100 sensor,  4-20 mA current loop transmiter, and a python app for visualization
  5. View File Temperature measurement using Arduino Nano, RTD PT100 temperature sensor and 4-20 mA transmitter Temperature measurement usind Arduino Nano, RTD PT100 sensor,  4-20 mA current loop transmiter, and a python app for visualization Submitter Absolutelyautomation Submitted 04/01/16 Category Other PLC Demo Software
  6. Simulation in Foundation Fieldbus

    Hi Guys,  Did anyone performed the process value simulation of Rosemount 5300 Level Transmitter (FF Communication) using Emerson 475 communicator? The simulation jumper is not available physically on the device. The only simulation option in the hand held communicator available in the following path.  Configure>>Manual Setup>>Classic View>>Advanced Transducer Block>>Parameters1.. But that option too is highlighted and not editable. Can anybody help me how to simulate the value from device so that I can check in my host DCS (Siemens PCS7). Thanks in Advance, GJ