Search the Community

Showing results for tags 'timeproportionalout'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 1 result

  1. Design Improvement Ideas : I currently use a 24v DC slipping brake (either Clarke or Warner) to prevent a reel of film from over-rotating - With Previous motion controllers - i have used timers at first then progressed to using a Virtual axis and a switch to make my pulse from NX- Digital output card to a Solid State Relay  (PSWITCH command for anyone familiar with TrioBasic) and this has worked pretty well. I have the same physical setup on a new piece of machinery but am now using NJ and Sysmac - Have used a TOF and TON in inline ST to control brake and it sort off works - brake can feel a bit lumpy and can chatter and bounce a bit adn am worried about the reliability when the machine is running and the controller is doing more. (brake cycle time t#10ms and tried at 100ms also) I did try using the Time Proportional Out FB - but this was far worse than the above. I think i will try my luck at created a new virtual axis e.g. Rotary Mode - min 0 max 1000 Run with MC_Move_Velocity when Machine is running and use an MC_digital Cam Switch to create my output Pulse. I am new to the Forum and trying to get more involved with others rather than working in Isolation - so wondering if anyone has any suggestions or thoughts  or have done anything similar in SS? Thanks in Advance,