Search the Community

Showing results for tags 'sysmac studio uploading'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 155 results

  1. Omron releases new 'SUPER-PLC' http://www.omron.com/media/press/2015/04/i0401.html
  2. Omron Releases a new entry level NJ Sysmac CPU. This new controller targets application up to 0 or 2 EtherCAT Axis. http://www.omron.com/media/press/2015/04/i0401.html
  3. I successfully read the input and output of OMRON PLC CPM2A with Indusoft web studio (IWS) by using OMPLC driver. I have select OMPLC driver (Serial Com). Then configure a driver worksheet. The driver worksheet is the place that PLC tags are associated to InduSoft tags. I successfully read the I/O but I failed to write the I/O of PLC by using IWS. Can you help me? It is difficult to find OMPLC Standard Driver Sheet (SDS) for control relay output block (CROB) and Analogue output block (AOB). The attached diagram shows My Standard Driver Sheet (SDS) setup. Thank you for your kind cooperation. Zack Malaysia
  4. Omron IA221 input cards

    Hi all, I recently got an old rima rs-12 counter stacker working. It was out in the plant working flawlessly until apparently the wires going into the power supply magically ripped themselves out. The operated hooked the wires up again but mixed them up(both black). When he powered up it instantly tripped a breaker inside the machine. He switched them and turned it back on to find that the flippers and pusher no longer work. The two omron IA221 input cards that control the flippers and pusher no longer have lights on them and I have found multiple open and short capacitors on the cards. The cards are 110VAC and I'm thinking the reversed polarity shouldn't have affected the cards, perhaps there is a greater problem I need to resolve before repairing and installing the cards. Could this have damaged the PLC itself? Any information will be greatly appreciated. I know it isn't really a PLC problem(or maybe it is.)
  5. Is it possible to run the NJ simulator in Sysmac Studio and have it communicate with a real NA HMI? Thanks.