Search the Community
Showing results for tags 'fx50 d700'.
Found 5 results
-
Hello Every body Peeps, I downloaded the GOT2000 comms manual where it describes how to connect to the D700 DIRECT on the PU port. I then placed the D700 template of the HMI from GT Designer 3 onto a GS2107WTBD. Parametized the drive, etc. In the template I changed the devices to match the station of my drive which is 1. i.e. on the template I had Device 0-0 SP122, for start forward, i then put my station no. 0-1 SP122, and that works. However, other than that, and the stop nothing else works, despite changing the station no. on devices, but I read in manual that if Pr 37 not 0 and SP127 = 1, then HMi cannot monitor SP109-111 which are devices used in my amps and speed setting, which they are not displaying on HMI. I can change Pr 37 to anything other than 0, but i have no idea how to change SP127, which description is Link parameter extended setting. Any ideas? Thanks.
-
Hello. I'm a newbie. First project. So I need to connect the inverter to PLC and I have used inverters RS485 port and PLCs inverter input. I have made sure the wiring is correct and used a 100 ohm resistor as was shown in the manual. At least I hope its correct. I have set most of the parameters as follows: P117 0 P118 192 P119 1 P120 2 P121 1 P122 9999 P124 0 P340 10 P502 0 P549 0 But still when I'm loading work on PLC then Module diagnostics is hitting me the error code H7602 that the communication has timed out and I don't know what to do. Is it my parameters? I have checked the parameters in the gx works 3 also so they matched and now I'm stumped. Please help
-
Hello Everyone I have a problem to connect FX5U with Inverter Mitsubishi D700. ( no respond from inverter) . I did read and following the manual. Could any one can help me?
-
I am developing an application with fx5u with inverter d700, it fails to send a command to the inverter, only running the application and monitoring the clp does not appear to fail, only when it sends a command. Attached photo of plc configuration and error. Do you have any secrets to doing communication, can I do it with a normal network cable? I'm doing with just one inverter, as the terminator should be at 110 or 330 ohm.
-
I am making an application with a fx5u with 4 d700 inverter, what is the way to communicate with them and the configuration in gxworks3, someone has an example in ladder.
