Search the Community
Showing results for tags 'fx3s morbus'.
Found 8 results
-
Greetings Can someone tell me about a memory that saves the data even when the machine is turn off? I need one for a speed pulse for a driver and all the memorys that I used where not saving the data. The PLC is an FX3S-MT32
- 2 replies
-
- fx3s
- mitsubishi
-
(and 2 more)
Tagged with:
-
Sorry for my bad english speaking. I want to change the baud rate to 19200,38400,.... for send it via Programmer-Serial-Port. The software GX-Developer can do it!.
-
Hi all, im using a fx3s along with a gt21 hmi, I’m asking for help with a timer programme, I looking to create a programme that will run a pump for 50 mins every 70 hrs of run time, I would like to adjust these values on the hmi as and when required. is this possible? thanks
-
Dear all, I had bought a mitsubishi plc fx3s-20MT/ESS which is the source output and I plan to try to send pulse to Mrj3a Servo Drive. According to the manual, it stated that the servo drive able to support the source type plc but I do find out that manual also mention that only sink type plc is suitable for melsec servo drive. Anyone can help me in this case?
-
Hi guys, I am an Electrical engineer on a cruise ship. I have a mixer (galley equipment) that is controlled by a FX1S-10MR PLC. It uses HMI F930GOT-BWD-E. Recently we found the PLC to be malfunctioning and replaced it with a new one from our stock. The new one is FX3S-10MR. Now, when i try to increase or decrease the speed via the HMI, the PLC doesn't respond; infact, the inverter just maintains a single frequency. The PLC is "supposed" to be pre-programmed by the manufacturer of the Mixer. I have very less knowledge of PLCs and sorry if i come across as stupid. I have been reading a bit lately. Do you think it would work if i can copy the program (from the FX1S PLC of another working mixer) by using GX works2 / GX developer software and write it on this new FX3S model ? What will happen if i change the type of PLC of this FX3S model to FX1S (just speculating since it's working find with FX1S). Today i tried to view the program inside this FX3S plc on GX developer and it does have a program. I am clueless though why it's not working with the HMI. Kindly, provide me with some guidance. TIA.
-
I could do with a bit of help I am trying to control 10 frd 720 inverters over Morbus with a fx3s fitted with fx3u485ADP-MB adaptor. All wired up ok with Mitsubishi cable to their spec . So I think I have a problem with my code in the PLC does anyone have a working program that I can modify for my machine Regards Smythe
-
Hi, all version gx work2 can support FX3s? Im using version 1 gx works 2 and currently got new fx3s-10mr/es w/out program..i tried to make new program but fx3s ot included in this software
-
Hi, all version gx work2 can support FX3s?