Search the Community
Showing results for tags 'dst setting'.
Found 8 results
-
Is there a bug in the daylight savings feature of the HMI? I have the checked in the HMI but the time didn't update to fall one hour back in the fall. Now the HMI is showing one hour ahead. Am I missing something here?
-
Hello! I have an FX1N PLC that I want to use to operate a sprinkler system. It should have two functions. 1. 1x30 minutes of operation every day. 2. 3x10 minutes of operation every day. Thanks for the help.
-
Hello everyone, I want to ask,, Does address mapping use this concept to do "remote i / o station" can be done? following the network parameter settings for CCLink and I tried to program with this ladder, is that correct?
-
Is it possible to change the range setting for NX Analog IO cards?
TigerLily posted a topic in NJ Series / Sysmac Studio
I am beginning my first project with the newer NX platform and am a little confused by the description in the manual vs what is actually in the sysmac setup. The manual makes it sound like you can adjust the range settings for the card, but I don't see any where to do it in the setup. I also don't know what the Index and sub-index columns mean, so I am wondering if this is a back door to access the range settings? -
hello everyone,,,, I want to running the motor in 100 rpm but how to setting electronic gear to control speed in servo motor HG-SR502,, does anyone know how?
-
hallo all, I want to ask if I click "read PLC Data" the "points" will appear, I use the QY18A output module that uses 8 points but there is no choice, the smallest is only 16 points. so I can't put 148 in the "start XY" column ... will it affect the I / O address in the program?
-
Dear Friends, I want to set my servo controller overload setting as per my machine load requirement since all my servo installed in my machine over travelling and hitting trying to run continuously which is resulting servo failures ,repeated timing belt cut issues.Kindly help me resolve this issue.since i am not familiar with servo controllers.Model used A5 II minas servo MADKT 1507 and contol mode in position control setting.
-
Hello everyone! I need your help. I use the PLC: Q06UDEHCPU and the module: QJ71MB91. I programmed in the program GX Works 2 I instaled a library of "QJMB91ModbusSerial_V120 (FB - QJMB91ModbusSerialMaster)" and using it wrote temperature sensor interrogation program. The sensor is interrogated by the channel 2 and has the following switch settings: Switch 1 - 0000; Switch 2 - 0000; Switch 3 - 0000; Switch 4 - 0A04; Switch 5 - 0000; which are specified by the PLC parameter in GX Works 2. I found an example of writing a program to install the switch settings in the user manual QJ71MB91 using ZP.UINIT instructions. I wrote a program to this exemple. Not prescribed bit address, which should be established when the program is executed (M0) (ZP.UINIT "U4" D0 M0). I wrote: ZP.UINIT "U4" D0 . After executing ZP.UINIT instruction PLC stops working, blinking error, settings module is not install. How can I write a program to configure the Switch Setting?
