Search the Community

Showing results for tags 'c programming nb designer'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 207 results

  1. Hello all, I am trying to download a new program to a AB 1746-BAS SLC 500 BASIC board via RS-232 connection through a Windows 98 laptop running Hyperterminal. While the BASIC board is connected I verify connection by waiting for the board to print out its information in the Hyperterminal program and then enter "CLEAR", "NEW" and finally, "LIST" in Hyperterminal to wipe any program from the board and verify the board is clean respectively. Then I load the new program via a .TXT file using the "Send Text File" option within the Hyperterminal program. After the program has finished loading I than type "LIST" to verify it has copied over correctly. I than switch the SLC over to "Program Mode" via the key. After doing so I type "RAM" to select the program i just uploaded to the BASIC board and then type "PROG" in the Hyperterminal program. I than receive the "Programming Sequence Failure". If anyone has any advice as to what I am doing wrong it would be greatly appreciated. Below is a list of everything I have set and researched. Thank you in advance, James -Laptop: Windows 98, Hyperterminal -BASIC board (programming): JW1 pin: 1-2 3-4 JW2 pin: 1-2 3-4 JW3 pin: 1-3 2-4 JW4 pin: 5-6 3-4 -RS-232 9-pin connector: Pin 2 connected to Tx Pin 3 connected to RX Pin 5 connected to ground Pins (4/6) crossed DSR/DTR Pins (7/8) crossed RTS/CTS -Hypterminal: Direct Com1 bits per second: 1200 parity: none stop bits: 1 Flow control: Xon/Xoff Settings/properties: -> Emulation VT100 -> ASCII line/character delay: 30 milliseconds check box: Append line check box: Wrap lines... -Manuals: 1746-rm001 1746-pm001
  2. Dear all, I need some help with programming time in concept 2.6 in FBD. I use momentum PLC 171 CCC 980 30-IEC I would like to program 24Hours Clock with day, week and year. Can someone help me with this please. Regards Sam
  3. Buy what PLC?

    Hi I want to buy a PLC and additional required stuff, to play with at home. Where do I find cheap PLCs? What software do I need to make this work with a Windows 8 PC? What other physical interface and software is needed/recommended?
  4. Hi, Is there any good documents out there on how to download to a NS15 Omron HMI from CX-Designer via Ethernet? Thanks, Andrew
  5. FX2N-232IF module programming

    Hi All, I want to connect 3 nos. Barcode scanner with FX-3U PLC, So I am using 232BD card, 232-ADP card and 232-IF card. I need help for FX2N-232IF card programming for Motorola Barcode scanner. I am already done programming with 232-BD & 232-APD card using RS Instruction. But in 232-IF card TO/FROM instruction required. Anyone have FX2N-232IF Card program sample so please send me. My mail id:- mohitkumar1188@gmail.com
  6. Texas Instruments TI 164

    Any one out there have a programmer for one of these old PLC's or can any one recommend some where I could send one and have the program printed off for trouble shooting ? Thanks !
  7. Dear Mr/Ms, I using GT designer 3 to simulate have to use GX developer. But I can not install GX developer, just using GX works2. So Can I connect GX works 2 and GT designer 3 to simulate.. Please help me to slove this problem.. Thanks & best regards,