Search the Community

Showing results for tags 'SICK'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 4 results

  1. Hi guys. I have a new SRM50-HAV0-K01 sick encoder for my ELAU servo motor (model: ELAU sm 070-60-010-P0-45-M1-B0), and need to program it according to an old one (which seemingly is broken) via hiperface. device: PGT-11-S LAN software: SOPAS 2018.3 build 4.1.1.324 (Vm version 1.8.0_73) I tried to find any certain way for programming of sick encoders on the net using the mentioned device and software, but cant. all is only about datasheet or how to use teh software without an specific instruction. I am not even sure of that the old one is broken, except that in the analysis mode of the SOPAS (entering via hiperface) I can see the the  sin-cosin graph out of its limitation line. The thing is I have bought a special tool which has not any specific instruction and SICK group does not reply any exact instruction for my issue. Here is my questions:   How can I program the new encoder just according the old one?   And how can I assure that the new one programmed just as the old one?    and what is the definite sign of a broken encoder?   anyone experienced?
  2. Hello all. i am new with this plc. I have created a message to send to my device via network configurator everything works properly. I asked if there is the same possibility to send the message through Sysmac Studio I enclose the photo. My device is Encoder Sick AFM60A, it is for setup preset. with Allen Bradley i use send message. we have the same possiblity with Omron? Thx all
  3. Component test

    Hello all, I want to carry out some small tests on the reflex array WL27-3P3402S17, but I am not sure what's the simplest way to set up the array.(I just need to be able to read the values from the array). Is it through PLC or are there other options ?
  4. Siemens S7-1500 and SICK

    Hello all, Let me start by saying that although I have been working with PLCs for 20+ years I am very (as in brand) new to the Siemens world (my wheelhouse is AB). That being said I have a Siemens S7-1500 (1511 specifically) CPU with a couple of SICK multi-turn Profi-Net encoders (AFM60A-S4NB018x12) that I need to talk to. - I am using TIA v13 with all of the updates. - I have the GSD file from SICK for the encoder. - I have no clue what I am doing - I can see the encoder values update in the watch table as I move the encoder. All fine and dandy so far... Here's where the white flag is going up.... - I am of the belief that there are existing function blocks out there 'somewhere' that can read and write to the base parameters. I have contacted our local rep who deferred me to SICK. I have emailed and left messages with them and have not gotten a return anything thus far. Here's our application... We are attaching each encoder to its own rotary gear mechanism. The rotary will need to turn in the CW direction approximately 400 degrees then return to its start point by rotating in the CCW direction by the same amount. If/When production/maintenance needs to 'rehome' the assembly, the expectation is that they 'pin' the drive in a known location then a bit would be set within the CPU that would assign a specific value to the encoder's actual position. In the SICK manual (8015078/YIX6/2015-01-16) on page 31 (section 3.6.3) there is reference to Preset control. This is what I believe we need to perform the aforementioned function. Does anyone have any examples that they could share on how to read/write to these encoders by use of a Function Block or other? Relatively desperate for help at this point. Can post test code if need be. Thank you in advance, TLAF