Search the Community

Showing results for tags ' mitsubishi compact'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 334 results

  1. Dear Messrs., I need information to reverse engineer a GML diagram from the uploaded script. 1)Documentation for GML script language (iCODE ) Thanks,
  2. I am trying to find a way to do a "batch monitor of Global Labels" in Mitsubishi GX Works2 Software. I can monitor Device/Buffer Memory Batch but can't find a way to monitor all Global Label's status online? Can anybody help me on this?
  3. Dear Sirs/Madams, I am studying to connect between GOT1565 and Microcomputer/PC via RS232 However, I only see the documentation for GT-A900 and GT-F900 So, I'm wan to ask you: Can GT1565 connect with Microcomputer/PC via RS232? Who did it? can you help me? Thanks so much!
  4. Hi All, I have problem about programming serial module Mitsubishi PLC using QJ71C24N. If I unconnect the cable from the module and connect again it show SIO error and the communication become lost or not sending data again. so i have to restart the PLC to make it normal again. Any other solution for solve this error without restart the PLC? Thanks Husanto
  5. Non-volatile memory GX Works2

    Hi all, Im trying to figure out how to create non-volatile memory tags in GX Works 2 (using a FX3U controller), so that the values stored in the D registers won't keep zeroing out every time the controller powers down. Does anyone have any helpful tips on how this is done? Thanks
  6. Mitsubishi QJ71PB92V and Balluff BNI PBS-507-000-Z011

    Hi all! I need advice. I have Mitsubishi Q02UCPU with profibus module QJ71PB92V. I try to connect communication module from Balluff BNI PBS-507-000-Z011 via Profubus without success. Everytime I connect module, I see diagnostic alarm "The parameter transmitted by the master is incorrect". All settings were made by default. QJ71PB92V has 0 adress and Balluff BNI PBS-507-000-Z01 has 11. I connected this module to the Siemens CPU-315 and it is work correct. From this forum I see it is common error. What will be the next step to check or solve the problem? I am not profficient in Profibus networks, so I will be appreciate for any help!
  7. Help with carwash / FX3

    Can anyone help with a carwash program? I am currently a student and having a very hard time getting this to work. I am using GX2 software. Any help would be greatly appreciated. Jeff
  8. Dear experts, I have been trying to flash parameter to QD75MH1 module from PLC. Every time I monitor the servo via GX-configurator QP, I find 0 error, 0 warning but in the history tab it shows "start not possible(108)". But when I did it by flashing the parameter by GX-Configurator QP(Specially invalidating forced stop option" it works fine and servo motor jogs. can anyone help me to write the forced stop value from PLC program?
  9. I need to change the IP address of an existing PLC. Only access I have is remote (VPN). Is there any issue with downloading the same program - with the IP address changed - to the existing processor? Then change the local network range to match, etc...