Djoko

MrPLC Member
  • Content count

    27
  • Joined

  • Last visited

Community Reputation

0 Neutral

1 Follower

About Djoko

  • Rank
    Sparky
  • Birthday 05/01/81

Profile Information

  • Gender Male
  • Location Jakarta
  • Country Indonesia
  • Interests Swimming

Recent Profile Visitors

361 profile views
  1. QM30VT2 BANNER WITH QJ71C24N

    Dear Sir. Can Anyone Help me,How To read  Holding Register QM30VT2 BANNER With QJ71C24N Mitsubishi ,With Rs 485 Communication.I Want To read Holding Register it,More than 2500 Register. Thank you for attention. Best Regards.
  2. Until now my problem about Qj71mt91 has not been resolved and I have contacted a technician from the Mitsubishi agent but it has not been resolved either 😑😑😑
  3. Master . Cpu  IP = 192.168.3.30. QJ71MT91  IP = 192.168.3.40 SLAVE 1. CPU IP = 192.168.3.50. QJ71MT91 IP = 192.168.3.60. SLAVE 2. CPU ( Q02 H CPU ). QJ71 MT91 = 192.168.3 70 I've tried it, without a CPU connection to Ethernet,But still problem
  4. there are no other devices connected to , only a notebook and 3 modbus installed 
  5. If Master and slave 1 are connected  ,slave 2 cannot pinging,sometimes it can be connected, after 12 times time out
  6. there are no other devices connected to , only a notebook and 3 modbus installed 
  7. there are no other devices connected to the switch, only a notebook and 3 modbus installed 
  8. there are no other devices connected to the switch, only the laptop and 3 modbus are installed, but when the master and the first slave are working, the second slave cannot  pinging , after being removed from the switch and  installed directly into QJ71 without the hub being connected
  9. only slave 1 and slave 2 are configured by distinguishing the ip address.Other parameter not set
  10. Hello mr.@NevergoldMel. Can you show me example? How to configuration master and 2 slave Qj71mt91 ? 🙏🙏🙏
  11. Thank you sir. I have move cable slave 1st and slave 2nd, it's Working and success.but still problem when connect to second slave.there may be an automatic communication parameter error between master and slave, and I haven't found a way to set it
  12. Slave 1st .192.168.3.60.       Slave 2nd.192 .168.3.50. If slave 2nd ( qj71mt91) test ping direct with straight cable to PC has success,but if through switch cannot responding. Whats wrong ?
  13. I have make automatic communication parameter 2 with different IP and BFM,But  Still problem ,Cannot communication with second slave ,Alarm appears on diagnosis system monitor