ARV1992

MrPLC Member
  • Content count

    7
  • Joined

  • Last visited

Community Reputation

0 Neutral

About ARV1992

  • Rank
    Newbie

Profile Information

  • Country Cuba
  1. CJ1M-CPU11

    Michael I finnaly did it I could load the program and read from PLC thanks Greetings from Cuba Best regards
  2. CJ1M-CPU11

    michael I finally did a comunication with the plc I change from pc and install the cx one again in a laptop. Now I could read from PLC but i have a program taht i want to load in the plc but i can't when i get online with the plc i can't do nothing. if i have a program how can i load to the PLC I use finally an usb-serial port adapter
  3. CJ1M-CPU11

    look this error
  4. CJ1M-CPU11

    Michael Walsh I did it but when the cx programer do the automatic online search at the end show ¨failed to connect to plc¨
  5. CJ1M-CPU11

    yes i 'm using that rs232 cable but i have the bridge betwen 4-6 7-8 in the female and 5-4 in the male. 2-2  3-3 and 5-9. I dont have the bridge betwen 7-9 in the male conector in the female conector I dont put pin 1 to shield
  6. CJ1M-CPU11

    yes i 'm using that rs232 cable but i have the bridge betwen 4-6 7-8 in the female and 5-4 in the male. 2-2  3-3 and 5-9. I dont have the bridge betwen 7-9 in the male conector in the female conector I dont put pin 1 to shield
  7. CJ1M-CPU11

    HELLO EVERYONE. I have the following modules and I cannot communicate with the PC via serial port. PA202 / CJ1M-CPU11 / AD041 / ID211 / OC211 IN THIS ORDER The following LEDs are on: Run, Comm. ERR / ALM IS BLINKING IF ANYONE COULD HELP ME THANKS