Megoof

MrPLC Member
 View profile  See their activity

  • Content count

    9

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Megoof

  • Rank
    Newbie

Profile Information

  • Country United States
  1. Megoof started following SLC 500 and SMC Ex260
  2. I'm trying to connect a SMC EX-260 to a Allen Bradley Micrologix 1400 PLC so  I can run some valves with it. However, RsLogix 500 doesn't allow me to just setup a generic ethernet device like I would on RsLogix 5000. Is there a way I can communicate these devices together so I can use the SMC Valve system with my Micrologix?
  3. Megoof started following Ethercat Communication Recovery
  4. Good Morning, I have  question about Ethercat Configuration in Sysmac Studio. So we have a system where  I work that has an Ethercat network, and I have noticed that when we kill power on one of the slaves during operation, when it turns back on, communication is not re-established. Only a full system shutdown or a redownload of the EtherCat Network seems to fix this. Is there any setting in the Master Device that can be changed that would allow this to happen?    
  5. Megoof started following Comments are lost in "Transfer From" during sync
  6. Hello All, I am having a small issue that I hope has an easy solution. Whenever I plug into another project and try to "Transfer From" during sync, my NX102-9020 says that the PLC does not have comment information and cannot be restored. Is there some setting on Sysmac Studio that needs to be checked so I can pull the comments from the PLC? Any help is appreciated.    Thanks
  7. Anyone know of a guide about programming a balluff io master device into Sysmac Studio?
  8. Megoof started following Sysmac Studio - ETHERCAT
  9. In Sysmac Studio, I want to add some devices to my network using the Ethercat setup in Sysmac Studio. How do I add devices that do not come as part of the initial install, like a Balluff IO Master, for example?
  10. In CX-Programmer software, we have the ability to make a bunch of copies of the same rung with the "Address Incrememntial Copy" Function. Does Sysmac Studio have a similar function?
  11. Megoof started following Sysmac Studio - Adress Incremential Copy

  12. Using a AD041 and DA041

    Megoof replied to Megoof's topic in Omron

    I see, but what about getting my voltage to output at say, 5 Volts? I can't get that to show up.
  13. Megoof started following Using a AD041 and DA041

  14. Using a AD041 and DA041

    Megoof posted a topic in Omron

    Hi, I'm using a CJ2M CPU 33, and also a CJ1m Ad-041-V1 Analog Input and DA-041 Analog Output card.  I am using the Analog input to measure my current in my one heating application and  Ihave that reading and scaled correctly, but now  I want to use my Analog output to replace the Rheostat  we have in the system. I'm having some issues setting the range and getting voltage to vary. I also am a little new to Analog Outputs and don't know what I'm doing wrong. I have attached my program here. Any help would be greatly appreciated. Analog Heat.cxp

  15. Analog Output Simple Problems

    Megoof replied to budimanc's topic in CX-Programmer

    Where is the sample program? It doesn't seem to be attached