xcyong89

MrPLC Member
  • Content count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About xcyong89

  • Rank
    Hi, I am New!

Profile Information

  • Country Malaysia
  1. Hi All,I aim to use Aveva Plant SCADA 2020 to read and write data from/to Omron CJ2M CPU35 PLC using OMFINS protocol. However I have Bad Data (Not #COM) in runtime.The setting of SCADA and PLC shows below:a. Omron CJ2M CPU35 built in Ethernet CJ2M-EIP21 - Unit 0, Node 10, Network :1, IP Address: 192.168.1.10, FINS/TCP Port: 9600.Declared Symbol: A_Test_AI1, INT, D501, Publicationb. Aveva Plant SCADA 2020Network Address: 192.168.1.1{Boards} Server Name: IOServer1, Board Name: BOARD1, Board Type: TCP/IP, Address: 0{Port} Server Name: IOServer1, Port Name: PORT1_BOARD1, Server Name: IOServer1, Port Number: 1, Special Opt: -I192.168.1.10 -P9600 -T{IODevice}: Server Name: IOServer1, Name: Omron_PLC, Number: 1, Address: 1/10/0/V, Protocol: OMFINS3, Port Name: PORT1_BOARD1, Automatic Refresh: TRUEDeclared Variable: A_TEST_AI1, Cluster1, Omron_PLC, INT, D501{Citect.ini}: [OMFINS] Source: 1/1/0I able to ping 192.168.1.10 (PLC IP address) from SCADA PCFrom Kernel, I have error message below:Error: Unit offline UINT 000c PORT1_BOARD1 Omron_PLC Error_in_CMD-3 16 Generic 000012 Driver 0000022 (0X00000016)Appreciate that if anyone can give some hint to solve the problemThank you in advance
  2. Hi, I have setup the Simple PLC communication in RJ71C24 (Channel 2) for communication between Mitsubishi IQ-R series PLC (Mosbus RTU Master) and multi drop Modbus RS485 Slave devices. The Simple PLC Communication Setting shows below: Just wonder is there any communication error flag to indicate communication fail for each communication request in Simple PLC communication ?
  3. I am facing a Proface HMI device with password protected, the device is not allow for me to backup the graphic unless I key in the correct password. The HMI model is GC4501W.   Appreciate if you can share the method to hack the Proface HMI password.
  4. Hello everybody,From user manual "ControlLogix SIL2 System Configuration", SIL2 Add-on Instructions is required to configure SIL 2 PLC application. However, the Add-On instructions can only be obtained through RA.Due to poor support of my RA, can anybody help to provide the SIL2 Add-on Instructions in here?Thank you for advance.