Hi there, I am considerably new with setting up E/IP on OMRON's NX1P2 PLC. I have been trying to connect a Keyence IV-G to my PLC with E/IP connection (because there's no analog I/O available) and struggling with getting a connection going between PLC and camera. I connect these two through an unmanaged network switch, which I believe doesn't need any further configuration. I have set tags on Built-in E/IP inside SYSMAC Studio, and when I monitor them it says "normally resolved". Unfortunately, it still has red dot which means connection is cannot be established. The error I'm getting is "Tag data link connection timeout". Maybe built-in E/Ip just doesnt work for this case? I have yet to try getting connected with Network Configurator, but have the feeling that it will just accomplish the same thing that I did with Built-in E/IP inside Sysmac Studio.