I have a Reliance Electric Drive Digital I/O Module 57401 that won't close the MCR contact R1/B3. I believe I've narrowed the problem to the 4 input signals WDOK, BD INIT, INIT, FAULT on the Multibus. Does anyone know how to access those signals from AutoMax Executive. I have also made a breakout cable, out of an old output card to access those signals. The problem with the breakout board is that P1-16 does not carry over to the empty slots 5, 6, 7, 8 and slots 11, 12, 13, 14 are full with the drive cards in question. I would also like to find out what drives those signals, especially the Fault signal on P1-16 of the Multibus.