MrPLC Member
  • Content count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Mr.HL

  • Rank

Contact Methods

  • Website URL

Profile Information

  • Gender Male
  • Country Vietnam
  1. Thank you. After auto-configure is finished, it does not show success. The error shows "unable to verify setting..." like the photo above.
  2. Yes thank you, I've seen in the manual too, that we will not need a UIC cable, it will auto-configure. But now, we can not connect. 
  3. Many thanks, Everyone, The first time, I connected to Micrologix 1000 and it worked normally like the way by Mr @IO_Rack And then I want to connect it to an HMI and I tried to change "Channel configuration" -> download project to plc. After that, I can not connect. Now, I do not have a DH485 with a UIC chip cable, I used a 1761 Cable. If anyone has a DH485 cable please change the setting and then check.  
  4. Hello, thank you very much for your reply. I try many times to connect with the old driver but can not connect (including auto-configure). I will need a DH485 with 1747-UIC cable for connecting the micrologix 1000 with PC or not ?. My MicroLogix 1000 is Ser E. Please help me more. Thank you in advance.
  5. Hello everyone, I am a newbie with PLC. I have a Micrologix 1000. The last time I connected with RSLinx easy, however, I change it to DH485 (I do not remember exactly). And now I can not connect it to RSLinx, I tried many times for all types of drivers. Please help me. Thank you very much.
  6. A method of communication HMI Proface with PLC Delta DVP Link: Rgds,