photovoltaic

The official EDS file for the FHV7 Smart Cameras.

A Library containing a function Block that can be run on any Omron NJ or NX PLC. The Function Block will retrieve the host PLC's IP address, Subnet Mask, Gateway, and MAC Address. The Port Details are displayed through 2 structures , 1 per-port. In the event you only have 1 Ethernet port then the structure for the 2nd port will contain all 0s. Data Format:
IP Address - USINT[4]
Subnet - USINT[4]
Gateway - USINT[4]
MAC - BYTE[6]  (hex value)
Access the retrieved details by the typical parent-child tag structure. ex. Port_1_Detals.IP_Address[0] will get the first octet of Port 1's IP.
Tested on: NX1P2, NX102, NX502, NX7, and NJ301
IMPORTANT: This Function Block should not be run immediately after startup. Allow the PLC a few seconds to establish a connection with the Ethernet network.

A simple test program and starting values for the PIDAT instruction in Sysmac Studio. Simply run the simulator (Simulation-> Run) and toggle the Test_PID bit. Simulated feedback will allow the loop to operate normally. The setpoint can be adjusted by modifying the PID_SP variable. There is a pre-programmed data trace that traces the SP, MV, and PV.
To use the data trace navigate to DataTrace0 and start the trace, flip the Test_PID bit true and the trace will log 10k samples. Change the SP and view the behavior when the trace finishes.

NT Support Tool 4.87E
The registry fix included needs to be manually executed and will add Omron PT models with system versions 3.2/4.2

Place the 2 files on an SD card or flash drive. Follow update instructions in V117 manual section 4-3
https://assets.omron.eu/downloads/manual/en/v2/v117_na_series_programmable_terminal_hardware_users_manual_en.pdf

Sample code to set the RTC on a CP PLC. Individual sections can be enabled/disabled.