-
Content count
6 -
Joined
-
Last visited
Posts posted by underwater
-
-
11 hours ago, kaare_t said:Yeah, I just verified it and the ADP module does not support ModbusTCP. It depends on which CPU you are using today... It's hard to recommend an upgrade CPU without knowing which one you have at present time... But the MC protocol is documented via Mitsubishi, so you could write that one in C#. It's listed in the complete manual for the ADP module I believe.
Do you know to use mx compoment in other PC without " Communication Setup Utility "?
-
3 hours ago, kaare_t said:I don't think there exists any free open libraries for this. However, you should be looking into ModbusTCP which has loads of free libraries/classes for C# on the internet. I don't remember if FX3U-ENET-ADP supports ModbusTCP, but there are libraries for the non-ADP module from Mitsubishi, and most built-in ports from Mitsubishi now supports ModbusTCP. Which CPU are you using?
It's fairly easy to develop on ModbusTCP so this is a good and solid choice.
my plc engineer told me cpu we used that does not support modbus
can you tell me which mitsubishi cpu support modbus
thank for help
-
On 9/8/2016 at 9:20 PM, Boushard said:Finally everything work on the VB.NET app side!!
However I can't make a connection without the "Communication Setup Utility" installed on the pc.
The VB code is probably not the prettiest but everything work as it should.
Thanks to all of you for your help!!
Hi, do you have any way to connection PLC without "Communication Setup Utility", please help me
-
please help me
-
Anyone know any free libary to communication with FX3u-enet-adp, please help me ?
Note: I've used mx Component , it work very well but it is too expensive and I dont even know it can work in windows server 2012/2016 or not.
one more question, Is there otherway to make program run in other computer without install mx compoment, it is very huge to install in every client computer
Thank for reading and sorry for my bad english
Need help read data from omron CP1L using modbus tcp
in Omron
Posted
I using easymodbus library to connect and read data from 3 PLCs CP1L
but it run unstablely, sometime it disconnect and i cant re-connect PLC, it give error time out when i try to reconnect
when it happen, i restart PLC and everything back to work. Someone please help me. I am new with modbus and omron