SSK

MrPLC Member
  • Content count

    20
  • Joined

  • Last visited

Posts posted by SSK


  1. I had same error.did Uninstaller and reinstall.Updated version but error not solved.finally found solution.Just update in Tool-options-Ladder Editor-Ladderdiagram_Diplay Format-Display Connection of Ladderdiagram to 21 contacts.Then it solved


  2. In One of my machine we using one stepper drive thatCTA2H328M-MB model made by Centrust Motors China running without pulse input.Direction and  Enable input only connected. My problem is motor running in low speed since drive is 2.89 Amps and motor is 4.2 Amps so its not supporting.I want change drive capacity but i couldn't found a drive with same concept.I couldn't able to reach the chinese vendor.?c=msg&id=2337I have tried many drives which is in my stock all are enable input used for enable/Disable the drive.I am bit confuced.

    http://www.centrust-motor.com/?c=msg&id=2337

    Kindly help

    what type of drive is this?

    Which model will suitable for my requirement?

     

    ae03f5041be746fc6.jpg


  3. Hi Friends,

    In My new project I have used two Delta PLC'S (DVP-60ES2 and DVP 14SS2) I want to communicate both through RS 485 Communication protocol.We have  tried communication trough manual help.But Master Slave device not communicating.We have checked for any error code in D1130 but it always showning "K0" value.here with I have attached screen shots and complete program for yours kind reference.Kindly help and guide us to communicate.

     

    Master Error.jpg

    Master.pdf

    RS485 master trail 1.dvp

    Rs485 trail 1 slave.dvp

    Slave Error.jpg

    Slave.pdf

    Master Send-Receive.jpg

    Slave Send-Receive.jpg

    2 people like this

  4. Dear Friends,

    I am doing a pick and place project using stepper motor.programmed movement by PLS2 command and motion are running fine.I want to program origin for the stepper axis.Please help.

    i don't know how to origin with a home sensor input.I am using CP1E PLC and stepper driver DM860.


  5. Posted 22 July · Report post

    Dear Friends,

          I want to set my servo controller overload setting as per my machine load requirement since all my servo installed in my machine over travelling and hitting trying to run continuously which is resulting servo failures ,repeated timing belt cut issues.Kindly help me resolve this issue.since i am not familiar with servo controllers.Model used A5 II minas servo MADKT 1507 and contol mode in position control setting.


  6. Dear Friends,

          I want to set my servo controller overload setting as per my machine load requirement since all my servo installed in my machine over travelling and hitting trying to run continuously which is resulting servo failures ,repeated timing belt cut issues.Kindly help me resolve this issue.since i am not familiar with servo controllers.Model used A5 II minas servo MADKT 1507 and contol mode in position control setting.

     

     


  7. I am using CJ2M PLC.I want switch on a output for certain time by a timer and holding bit if interlocks satisfied.If interlock not OK timer has to hold the time and output should be off. if again interlocks OK again output has to ON upto balance time completion and has to give timer done output for reset holding bit.please suggest.