Hello guys,
I got a used Omron VFD from a friend. It was used in an industrial application. It works fine with the integrated panel. I would like to use it to run my drill press.
I now try to control it by the so called 3 wire sequence (S1, S2, S3) for Start, Stop and forward/reverse. System does not work as expected, i. e. no reaction on the switches. I'm not sure if I have messed up the configuration of one of the n xxx parameters or if there is a HW problem. With SC open, there is no voltage at that pin (expecting 24Volts?!).
Any thoughts?
regards and thanks,
Matthias
Current config:
n001 = 4
n003 = 1
n004 = 0
n006 = F/R
052 = 0
n176 = rdy
n177 = 1