marcunni24
MrPLC Member-
Content count
3 -
Joined
-
Last visited
Posts posted by marcunni24
-
-
Hello Veganic,
Yes, the PLC has other extension units. In order
FX3U-485ADP-MB / FX3U-4DA-ADP / FX3U-4DA-ADP / FX3G-CNV-ADP<--(Left Side)<-- FX3G-40M -->(Right side)--> FX2N-8EX-ES / FX2N-8EYT-ESS / FX2N-8ER-ES / FX3U-ENET.
Regarding the IP address, I did a network scan, using a direct connection (no router), and that's the address that popped up (also, in the FX-Configurator software, it was the default IP address that appeared).
Thanks for the response.
-
Hello all,
I´ve seen quite a number of similar posts regarding this topic, but none seems to address this problem in particular. I have an FX3G-40M, with a FX3U-ENET module.
I could establish a successful connection to the PLC via RS232. My problem arises when trying to configure the ethernet module (which I want to use for remote monitoring of the PLC program).
I've followed every step in configuring the connection. But when I attempt to do the WRITE operation (via RS232), I get the following indication:
"The module which supported this function is not found. Please execute again after confirming the module".
I can ping the module (as it has the factory IP 192.168.1.254), but can´t seem to download the configuration properly. When I plug the Ethernet cable, a green led lits up, and another one starts blinking.
I´ve found numerous posts regarding this issue, but all of them had a FX3U-ENET-L module. (And the solution was simply to use another configuration software).
The software I'm using:
- GX Developer-FX Version 8.91V
- FX Configurator-EN Version 1.30
Any hint you can give me of what can be causing this issue, will be very much appreciated.
Kind Regards
Martin
FX3U-ENET - Module not found
in Mitsubishi
Posted
Many thanks for the responses. I will try and let you know.
Regards.
Martin