Rishikesh

MrPLC Member
  • Content count

    14
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Rishikesh

  • Rank
    Sparky

Profile Information

  • Country India

Recent Profile Visitors

1082 profile views
  1. Delta PLC Analog Noise Reduction

    Hello All, I am Using Delta SE Series PLC and 06AD Module for Pressure Transmitter. But Analog input get fluctuate continuously. Is anybody have program for analog scaling.
  2. I am using FactoryTalk View Studio SE 8.20 to develop SCADA Application, and whenever I tried to open Tag Database it shows error "an error occurred while attempting to open the tag database editor" and not able to Open Tag database. Does anyone know solution for this? Error Screenshot Attached
  3. Is CP1H with Ethernet option board (CP1W-CIF41) is capable to communicate More than one client? If yes what settings I need to be Done?  
  4. If I Connect SCADA only then it works fine. SCADA is read only,HMI is read/Write in my case. Is CP1H with Ethernet option board (CP1W-CIF41) is capable of More than one client?If yes what settings I need to be Done.
  5. CP1H PLC with CP1W-CIF41

    http://www.omronkft.hu/nostree/pdfs/plc/cp1/pages_from_w462-e1-06.pdf This Could help you
  6. CP1H PLC with CP1W-CIF41

    Your Laptop IP address should be in same series of PLC to open in Web browser. ex-192.168.250.120  (In ur case).  
  7. yes..All Devices Have Unique IP Address. On local network HMI connected to PLC through Kepware OPC and SCADA PC used as read only SCADA. Whenever I connect only HMI it works fine as soon as i connect to SCADA and HMI both it starts swapping values in parameter(PLC Data Register). 
  8. Not able to connect CP1H omron PLC to Kepserver

    What could be settings for shown in image
  9. Not able to connect CP1H omron PLC to Kepserver

    255.255.255.0 is subnet mask.
  10. Not able to connect CP1H omron PLC to Kepserver

    yes its right, Managed Switch is not router it is in VLAN. But on SCADA PC i can go online to PLC through CX Programmer(It means it is in Network), but can not connect to PLC through kepware OPC.
  11. Not able to connect CP1H omron PLC to Kepserver

    Thanks For Ur Reply Mr.Pfort, I have configured device as CJ1 in kepware. Actually i am able to Connect to kepware on local network(i.e. 10.11.87.xx) but not able to connect on different network (i.e. 10.11.90.xx) .
  12. I have Omron CP1H PLC with Ethernet Option Board Installed on Slot 1. I want To communicate PLC to SCADA software through Kepserver OPC. But I am Not ABle to communicate with PLC on Kepserver OPC. Anyone Know Solution For This? Architecture is attached for more details.