sridharan

HELLO ALL I HAVE PROBLEM CX SUPERVISOR RUN TIME WORKING WHEN I OPEN RUN TIME AFTER 2 OR 3 HOUR IT WILL STOP AND COMMUNICATION CUT FROM PLC I USE OMRON PLC AND MT NETWORK  SETTING IN PLC  ETHERNET (FINS/TCP)  I GIVE ONE IP ADDRESS  172.17.0.85          AFTER CUT COMMUNICATION THIS MESSAGE WILL COMING MY PC    - COULD NOT WRITE TO PROJECT FILE. THE DISK IS FULL,WRITE-PROTECTED OR HAS BEEN REMOVED FROM THE DRIVER  ple told me some one  how to salve this problem    

hi i have omron plc cj1m  cpu-12 i need to configuration  analog signal input and analog unit i have AD041-V1   i need to know which one input address plc can any one told me how to make this 

hi i have omron plc cj1m cpu12 and i need make program analog input configuration but i don"t know input address i have analog unit AD041-V1 ple can any one give how to i can this  

hi every one i  i will use omron plc cj1m and all onron plc   but i need to know example DM3000 & DM2500  this each data memory have 16 bit how know bit-0, bit-1,bit-2,bit-3...........bit-16 what is tha address and this bit all how will work can any one tel me 

hi ple any one help me i use cx supervisor and i make one programming like scada   three machine have  omron plc so i connect this 3-plc with  Ethernet(fins/tcp)  but when i open cx supervisor run working good i can see all input and output but after one or tow hout pc have communication failure like this after close and open run time working seam one hour problem  plc any told me what i do this problem              thank you       SRIDHARAN