aliakbar

MrPLC Member
  • Content count

    11
  • Joined

  • Last visited

Community Reputation

0 Neutral

About aliakbar

  • Rank
    Sparky

Profile Information

  • Country Iran
  1. problem with cc link and st1h-bt connection

    i want to know for configuration module(ST1H-BT AND I/O MODULE) we need to configure GX CONFIGURATOR-ST or generate G.RDMSG for configtion module. may be need configure two procedure with together meter-950909-1.rar
  2. hello dear i have one redundant q12 h cpu and 2 st1h-bt node . i can read all input signal but i can not write in RY SIGNAL.  i try alot but my problem do not solved . i forced  output for example  y1038 to one but in the remote device station relative output is not active please help
  3. we have one redundant q12prhcpu  and i want to know why we should set redundancy item between two cpu . in all redundant cpu for example siemens and yokogawa  two cpu check all item and do all redundant item . but i don not understand advantage of setting these item by programmer.  
  4. CONFIGURATION PLC

    okey but i can not understand how this item works i have two node that connected to cc-link in the number one i have 3 analog input 3 analog out put and 4 digital input module and in number two 4 analog output cards i have i do not know hove i can configure these item
  5. CONFIGURATION PLC

    my arrangment is attached
  6. CONFIGURATION PLC

    my cc-link addres is 20h in my rack first power supplyq 61p and then q12prhcpu and after that QJ61BT11N  and at the end is  qj71e71-100 .
  7. CONFIGURATION PLC

    i want to know where i must to define our cards that installed on head station 2.bmp
  8. CONFIGURATION PLC

    hello dear i have one redundant cpu q12prhcpu and two ST1H-BT CC LINK V1/V2 HEAD station with few iI/O card connected to these head module. i want to know how i can define this two head station to cc link .
  9. CONFIGURATION PLC

    i work wih gx developer
  10. CONFIGURATION PLC

    HELLO kaare_t I HAVE ONE Q12PRHCPU REDUNDANT WITH TWO SUB RACK I WANT TO CONFIGURE PLC BUT I CAN NOT UNDERSTAND HOW I CAN DO THIS ITEM . ( MY HARDWARE (Q61P AND Q12PRHCPU , QJ61BT11 , QJ71E71-100)*2 PLUS 2 XT1H-BT ).  
  11. CONFIGURATION PLC

    HELLO DEAR I AM NEW IN MITSUBISHI AND I WANT TO START WITH PLC Q12PRHCPU . I WORK WITH GX DEVELOPER BUT I CAN NOT UNDERSTAND HOW I CAN CONFIGURE MY HARDWARE IN PLC . PLEASE HELP ME ABOUT THIS PROBLEM