Hi there!
I need to set up a communication link between an FX3GE PLC and a Melfa RV-2F-D robot with a CR750-D controller.
Can I use the PLC's built in ethernet port for this?
Is there a native driver for this (i.e. to read a register from the PLC into the robot controller)? Or should I use some kind of a no protocol communication?
We also have a GT1455 in the setup and had in the past a solution where the robot was talking to an FX3U trough the HMI, but there was a lag in the communication which I would like to avoid.
I am new to Mitsubishi so please bear with me. Thanks!