Donne
MrPLC Member-
Content count
11 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout Donne
-
Rank
Sparky
Profile Information
- Country Ghana
-
there is no medium of migrating Mitsubishi programs to siemens, you can only write new programs in the siemens by considering your existing inputs/outputs, sequence of machine operations.
-
Donne started following Schenk process
-
Thanks, these are the products: Disomat tersus, schenck terminal box, CPR -4 load cells.i need to wire the disomat tersus to the load cells, but when i did i had this faults message"weight currently invalid" pls help.
-
Hi, Any body with the idea how to configure and calibrate Disomat Schenck process on a weighing bridge system integrated to S7 400? Don
-
Donne started following wincc flexible
-
Hi, I have siemens KTP 1000 basic PN, i want transfer an integrated wincc flexible program into it. Please what are the wincc soft ware requirements to be able to do this transfer? what i intended doing is to install wincc flexible,wincc 7.0 runtime and config since i dont have wincc flex runtime. is this rite? please help. Don.
-
Well noted, but there are 5 switches at sys 1 and two switches at sys 2 which were at off position as machine was started until this problem occured. since all these switches are off, does it mean the program depends on the plc inbuilt RAM? if so then i tranfered the backup program to plc internal RAM but fault couldnot reset. kindly help on this issue pls.............................
-
thanks Gambit but please kindly show how i can find out if memory card is installed or not. thanks
-
Donne started following MELSEC Q2A PLC
-
Hi to all, i have melsec plc Q2A CPU error. i did plc diagnostics with the software and realise this error code 2300 and 2401. i reloaded the programme and tried to reset the plc but error still exist Please kindly help.
-
Donne started following plcsim v 5.4 sp1
-
Hi, trying to install siemens plcsim v 5.4 sp1 but error message pop saying 'SYSTEM MUST BE MODIFIED FIRST' kindly help with this problem. operating system is windows7 with S7 v5.5
-
Many thanks, but currently i have GX works 2 also but cannot find IEC developer, i found GX developer instead please what could be the problem since you said both are integrated in the GX works 2
-
ok but what is the difference between the IEC developer and the GX developer
-
I have a mitsubishi software programme in PCD file format and wanted to open the programme with GX Developer but couldnt open. Any one with an idea, help please