I actually figured it out. It was my keyspan usb to serial port interface. I was able to get ahold of a laptop with an serial port on it, and after that it was good. No I have another problem. The equipment is a lightning grid that runs up and down. It has and operator terminal that will tell you want height it is at. The terminal is an Mitsubishi mta-250. Now my numbers are way off. It should be sitting around 88ft but the operator is reading 2490. It's very close to the conversion of centimeters instead of feet. So I'm not sure if that is something in the Plc that I need to change. Kinda weird cause I downloaded straight from the old Plc which had the right distances and everything in it. So now I'm working on this problem. Any advice would be helpful. Thanks.