Randy765432

MrPLC Member
 View profile  See their activity

  • Content count

    5

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Randy765432

  • Rank
    Newbie

Profile Information

  • Country United States
  1. Has anyone used a LXM32 or an other Schneider Electric drive to a Kollmorgen servo motor? If so what needs to be done?    
  2. I did find the Red Lion protocol converter worked well, only with the PLC 5/20E processor with "E" ethernet. Randy  
  3. I am looking for a device to allow communications to and from a series 5 Allen Bradley DH+ to a Schneider Electric M241 Ethernet IP. Or what is the best way to configure the M241 and third party communications module to allow the communications to DH+. Randy
  4. Thanks for the info. It seems to be working well after since I tied all DC power supply commons and the linear position feed back to DC common. Randy    
  5. Randy765432 started following Schneider Electric TMC2AI2 analog input
  6. Having problems with the analog drifting. Over time the counts change. I have checked grounding and have tied the analog common to the DC common which helped clean up the noise. I am using a Balluff analog linear sensor 0 - 10vdc for the iputs. Both channels seems to drift. Any Thoughts?