Hello all,First time ASCII comms and I am currently trying to connect a Point I/O 232ASC card to a Keyence LK-G5000 laser displacement sensor via RS232C port.Logix5000 v.20.01.00I have the card and sensor wired as the manual suggests. I have the baud, parity, stop bits, and delimiters set as the manual suggests.The keyence has a MS,01 [CR] command that is supposed to reply back with the current measured value but when I send this command the only thing that changes is the Receive.Status. It will change from 0 to 16. Receive records does not increment. The keyence manual says it only needs the CR delimiter at the end and speaks nothing of a starting delimiter.In the 232ASC tags, I enter the command like this.Keyence:4:O.Data[0] - MKeyence:4:O.Data[1] - SKeyence:4:O.Data[2] - ,Keyence:4:O.Data[3] - 0Keyence:4:O.Data[4] - 1Keyence:4:O.Data[5] - $rLength set to 6.One other thing is the Keyence manual specifies the SD (TXD) pin as an input and the RD (RXD) as an output. So I have it wired as SD->TX and RD->RX.If anyone could give some advice as to if I have the command and length right, I would appreciate it. Like I said, I am not receiving anything back from the Keyence.
