hecateh

MrPLC Member
  • Content count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About hecateh

  • Rank
    Newbie

Profile Information

  • Country United Kingdom
  1. I have had a similar situation in the past, the setting for Total cable length on the master was set too low, it might be related? 
  2. NX1P2 Fins

    If you are using the NX102 then FINS is only supported on ethernet port 2. It looks like you are connected to port 1.
  3. That's what we suspected. Thanks for your help
  4. I understood it as each component has a PFH(d) or PFD(avg) value which is then used to calculate the entire system value to determine the SIL or PL. But I cant be sure as I am also not an expert on safety!
  5. Hi All, I have been asked to look for safety values for the NX Safety range from omron, I was able to find the PFH(d) values and the SFF but our process requires values for PFD(avg) due to the requirement of being a low demand mode system. I have been in contact with our local omron safety rep and they seem unable or unwilling to tell us these values, does anyone know where I can find them? Thank in advance!