mr.adi
MrPLC Member-
Content count
7 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout mr.adi
-
Rank
Newbie
Profile Information
- Country Albania
-
Hello I am a new user of phoenix contact. I have ILC 130 ETH controller and sometimes appeared FAL alarm on INTERBUS diagnostics. Please tell me more information about this problem. BEST REGARDS ADI
-
Hope this helps Best regards Adi
-
Thanks for your answer and your advice In diagnostic log the CPU do not request any OB so I am not sure if any OB can identify this problem. For more information i will send you all diagnostic log for this event. Event 4 of 10: Event ID 16# 4358 All modules are ready for operation Operating mode: STOP (internal) Incoming event 04:17:37.441 PM 10/13/2015 Event 5 of 10: Event ID 16# 4357 Module monitoring time started Operating mode: STOP (internal) Incoming event 04:17:36.646 PM 10/13/2015 Event 6 of 10: Event ID 16# 494D STOP due to IO error No relevance for user (Z2): 0000 (Z3): 0000 Previous operating mode: RUN Requested operating mode: STOP (internal) External error, Incoming event 04:17:36.189 PM 10/13/2015 Best regards Adi
-
Thanks for your answer How? I not understand. This problem occurs very rarely and the CPU goes to RUN mode only if I change a mode selector RUN to STOP than STOP to RUN. Best regards Adi
-
Thanks for your answer I have downloaded all ob that you say. OB1OB82OB85OB86OB100OB121OB122Best regards Adi
-
------------------------------------------------- Event 6 of 10: Event ID 16# 494D STOP due to IO error No relevance for user (Z2): 0000 (Z3): 0000 Previous operating mode: RUN Requested operating mode: STOP (internal) External error, Incoming event 04:17:36.189 PM 10/13/2015 ------------------------------------------------------- This is the message that i found on CPU message. So it did not call any OB. OB122 I have installed. I found defest on digital input, maybe it make a short circuit? Thanks Adi
-
Hello guys. i have installed cpu 315-2DP. It works well, but sometimes it goes to STOP mode and turn on the SF led. If i change the key from RUN mode to STOP mode and than from STOP to RUN, it works well again. I check all module and looks fine. Can you help me how can i find a solution for this case please? My HW configuration is like in a photo. Thanks Adi