mr.adi

MrPLC Member
 View profile  See their activity

  • Content count

    7

  • Joined

  • Last visited

Community Reputation

0 Neutral

About mr.adi

  • Rank
    Newbie

Profile Information

  • Country Albania
  1. Hello I am a new user of phoenix contact. I have ILC 130 ETH controller and sometimes appeared FAL alarm on INTERBUS diagnostics. Please tell me more information about this problem. BEST REGARDS ADI

  2. Template project in TIA Portal WinCC Flexible

    mr.adi replied to tecnoplc's topic in Siemens

    Hope this helps Best regards Adi

  3. Event ID 16# 494D STOP due to IO error

    mr.adi replied to mr.adi's topic in Siemens

    Thanks for your answer and your advice In diagnostic log the CPU do not request any OB so I am not sure if any OB can identify this problem. For more information i will send you all diagnostic log for this event. Event 4 of 10: Event ID 16# 4358 All modules are ready for operation Operating mode: STOP (internal) Incoming event 04:17:37.441 PM 10/13/2015 Event 5 of 10: Event ID 16# 4357 Module monitoring time started Operating mode: STOP (internal) Incoming event 04:17:36.646 PM 10/13/2015 Event 6 of 10: Event ID 16# 494D STOP due to IO error No relevance for user (Z2): 0000 (Z3): 0000 Previous operating mode: RUN Requested operating mode: STOP (internal) External error, Incoming event 04:17:36.189 PM 10/13/2015 Best regards Adi

  4. Event ID 16# 494D STOP due to IO error

    mr.adi replied to mr.adi's topic in Siemens

    Thanks for your answer How? I not understand. This problem occurs very rarely and the CPU goes to RUN mode only if I change a mode selector RUN to STOP than STOP to RUN. Best regards Adi

  5. Event ID 16# 494D STOP due to IO error

    mr.adi replied to mr.adi's topic in Siemens

    Thanks for your answer I have downloaded all ob that you say. OB1OB82OB85OB86OB100OB121OB122Best regards Adi

  6. Event ID 16# 494D STOP due to IO error

    mr.adi replied to mr.adi's topic in Siemens

    ------------------------------------------------- Event 6 of 10: Event ID 16# 494D STOP due to IO error No relevance for user (Z2): 0000 (Z3): 0000 Previous operating mode: RUN Requested operating mode: STOP (internal) External error, Incoming event 04:17:36.189 PM 10/13/2015 ------------------------------------------------------- This is the message that i found on CPU message. So it did not call any OB. OB122 I have installed. I found defest on digital input, maybe it make a short circuit? Thanks Adi
  7. Hello guys. i have installed cpu 315-2DP. It works well, but sometimes it goes to STOP mode and turn on the SF led. If i change the key from RUN mode to STOP mode and than from STOP to RUN, it works well again. I check all module and looks fine. Can you help me how can i find a solution for this case please? My HW configuration is like in a photo. Thanks Adi