Tarlochan Singh

MrPLC Member
  • Content count

    21
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Tarlochan Singh

  • Rank
    Sparky

Profile Information

  • Country India

Recent Profile Visitors

1379 profile views
  1. CP1E with TP02

    Dear All   I want to communicate CP1E with TP02 Delta HMI. Please suggest the solution. If possible please send sample program   Regards TS
  2. Omron R7D-BP02H Problem

    Please give me some idea to run manualy from software as i am online on CX-Drive but did not get manual command
  3. Omron R7D-BP02H Problem

    I want to mention that it was working with this setup. Currently under breakdown.
  4. Omron R7D-BP02H Problem

    ml_drive.sdd Drive1.sdd GLUING FINAL.cxp
  5. Omron R7D-BP02H Problem

    Dear All I am facing problem in servo drive as servo motor is not running even with the command given. Following pins are used and status is below Pin 1 - 24V Pin2 - 0V Pin 13 - 0V Pin 22- 24V Pin 23 -0V Pin 24 - 24V Pin 25 - 0V   On pin number 22 and 24 supply voltage coming during command given by PLC(CP1E output number 100.0 and 100.2) Need your support   Regards TS
  6. CJ1m CPU12 problem in ADO41-v1

    dear all   I am facing an issue in analog input connected with ADO41-V1 on channel one. Machine was working fine and suddenly analog card stop working, Only one input is used and configured on 2011, 0-10V coming on card    
  7. Dear All Please send me the link of USB driver of NB designer(V1.4) for window xp professional. I have tried "C:\Program Files\OMRON\NB-Designer\driver" but not working. Regards TS
  8. Load Cell programming sample for S7-1500

    Dear All   I am new user of Siemens and i need to communicate and calibrate the load cell with S7-1500 PLC Details are PLC-   CPU 1518F-4 PN/DP With simatic  ET200SP Weighing module - WP321 MLF number - 7MH4138-6AA00-0BA0 Load cell capacity - 150 kg to 1000kg   If anyone can give me sample program then it is very helpful to me.   Regards   TS
  9. CQM1H CPU51 SHOWING FATAL ERROR

    Error Code is 0x00F1
  10. CQM1H CPU51 SHOWING FATAL ERROR

    Hi all Fatal memory error is coming on CQM1H CPU51. I tried to reset this but after putting into run mode same error come again. The only option is left to restore all data and download new program but the problem is, Program is password protected and i dont have any backup. Any solution   Regards TS    
  11. Yes, Card is there in slot(128MB)
  12. Hi All, I am facing an issue in CJ1M PLC. I am doing some changes in programming and these are transferred successfully to PLC and PLC response according to changes. When we recycle the power of PLC all changes get deleted and plc comes to originally saved program. All other data like set values are not going to defaults. Any suggestions please 
  13. Software & Pinout Of Cable Plc Shilin

    Can anyone please confirm the programming software for Shilin PLCs  
  14. Change Date and Time

    Yes You can change the time of NB series by the dip switch settings TS
  15. RPM of motor with sensor pulses on CP1E

    MAX rpm of motor is 2880