sachincool786

about drivers i can't say anything. just 1 hub is there between plc & Hmi. 95% of the time communication is working fine. Sometimes randomly it happens.

Hello all, E1101 hmi is communicating with Q06 PLC on ethernet (Q PLC have ethernet module on its rack). Most of the time communication happens very much fine but Sometimes this error "error IP stn 41" comes & communiaction to the PLC gets break. Now until & unless I switch off & on the power of PLC communication won't happen. Please help PS: Pic is attached..

Thnx mate...

I have the same doubt..please anybody clear it. I have FX5U PLC, GOT2000, a Cognex QR Reader who have ethernet communication, a hub & ethernet I want to take immages of reader on GOT, how can i do it?? plz explain explain thoroughly. PS: GOT will also communicate to PLC in this mean time.

Thnx for the reply Sir, All the points u covered i already tested Sir, But no success.

& when was the last time you tried?

I have already seen this help. But could not understand. can you elaborate it plz?? how can i do it???

I have the same doubt..please anybody clear it. I have FX5U PLC, GOT2000, a Cognex QR Reader who have ethernet communication, a hub & ethernet I want to take immages of reader on GOT, how can i do it?? plz explain explain fully