Hello,
I am programming a Mitsubishi PLC with QCPU and trying to get an out put voltage from Q62DAN D/A Module. The switch setting is for 0-5v, Parameter for CH1 is 0:Enable, And Auto Refresh I lefted blank, I connect 24VDC to the card. wrote the program in the manual and change the I/O addresses to my I/O addresses(see the atachment please). But still I do not get any output. I noticed U8\G20.0-3 and U8\G20.4-7 in Intelligent Function Module Monitor are Unsigned and they show 4 to 20mA which is I set them for 0 to 5V. Does any body know where is the issue that I cannot get any out put from my card? Thank you in advance.