azoo

hello every body   I need help to upload the source code from F930GOT-BWD-C HMI  I am using  GT Designer 3  and PC connector  (RS-232C connector), D-sub, 9-pin  thanks 

its write ; They are physical inputs as emergency  or safety . But its not applicable to set a value to each "x" in the "setting digit" columns . what parameters mode  can stop this alarm  E6.1 ?   

i know that way to clear the 'E6' warning on a Mitsubishi Electric MR-J3 servo referring to link below  https://www.youtube.com/watch?v=fk9FiCxPiVk i matched but didnot work !!   

i used only motor power and encoder cables .. .. USB interface cable  and no option units . now  trying  to solve alarm AL E6.1 on sevro screen 

Hi every body ;  I have anew Servo Amplefire system consists of MR-J4-A  amp. with HG-KR motor without break  ;   after install  it run and i cant remove servo forced stop warning Alarm E6.1  ; i have not CN1 junction terminal block cable .  What is limitations  to do a free control using PC MR Configuration 2 ?? How to operate it with out command from controller ?  thanks for all ;   

my friends ... i followed ( MITSUBISHI_FR-E700EX_V_Ver2_E.pdf ) of upper example and link this cable ; but i have communication error !!!

hi every body ... i just ask about something in internal servo amplifier controlling ! how to get one pulse signal from mr-j4 after motor have been stopped ? thank you all

For diagram i need to Set the terminating resistor using the terminating resistor selector. is model GS2107-WTBD have this selector ?

Thanks Gambit :) Thank you for your help and I'm going to try .........

Hi , i am new with Mitsubishi devices. i want to connect and control FR-E700(SC) via GOT GS2107- WTBD but i confused about selecting suitable Connection cable ; after cheeked manual founded that this special cable prepared by user and i get a lotoff diagram's but i wandered with plug out terminals of RS422 & RJ45 !!! can you help ??