Chris Iwo

Hi JC,   Thank you Appreciate your help The PLC has "BATT Fault" on the power supply module[TSX PSY1610]-what does this mean? Thanks Chris  

Hi ALL, We have a Modicon TSX Premium PLC which has fault and cannot run I am searching for the software to program the Processor and how to talk to it Thank you Chris

Hi ALL, I have a GE PQMII,Redlion Data Station & GE LM90 30 PLC I am trying to map data out of the PQMII to Redlion using Modbus-RS485 and then using Ethernet (TCP/IP) to map data from Redlion to GE LM 9030 PLC. I know Modbus uses hexadecimal and PLC Registers are in Decimal I need a technical procedure on how to configure/program Thank you Chris Ok Tedi Mining Limited

Hi ALL, We a have Rockwell Automation FactoryTalk Machine Edition View Station 5.00.00 (CPR 9) that was working fine but just today, operators cannot reset/acknowledge alarms. I have checked network connectivity is okay I need assistance on what could be the possible cause? Thank you Chris

Thanks RussB

Hi All, We have a 4X Rx3i PLCs that use Ethernet Global Data (EGD) to talk to each other. At the moment we a facing EDG communication fault being generated and it trips the entire pumps What the likely causes of EDG faults: We have replaced PLC Ethernet Interface Modules-no fix We have tested the fiber optic cable-the readings show its OK Also,can someone explain what PLC heartbeat is?

Hi ALL, In the Rx3i controller fault table-the following fault keeps coming-up "0.4-LAN System-software fault: resuming" Error Code: 402 Group: 16 Action: 2 Diagnostic Task Num: 6 28001d001400000004011d000000000c0a88066 Does anyone have the definition of this error code and how I can interpret the error? Thanks Chris Ok Tedi PNG

Thanks Russ  

Hi All, I am trying to setup the communication between GEIP PACSystems Rx3i and Schneider Electric CitecSCADA 7.1 Does anyone have the procedure? Thanks Chris

Hi ALL, How do I convert a LM 90 30 (DOS) to a Proficy Machine Edition 8.5 software? Thanks Chris

Hi ALL, Can Schneider Electric CitecSCADA 6.10 talk to AB Micrologix 1100 via a Ethernet Interface Communication Module [1761-NET-ENI ]? And what Citec Driver can I use to set this up? Thanks Chris

Thanks RussB, Will try this

Hi ALL, Am trying to write a PLC code that will register accumulate tonnes from a conveyor weightometer What function blocks inside LM 90 70 can I use to develop this? Need assistance Thanks Chris

Hi, Am trying to setup communication between Allen Bradley Micrologix 1100 controller's ethernet port to Citec SCADA 6.10 What protocols can I use to have Citec communiccate with AB Micrologix 1100 controller? Thanks

Thanks RussB